Application Method Of Automatic Packaging Machine For Furniture Accessories

Application method of automatic packaging machine for furniture accessories

Preparatory work:

1. Clean the dirt, sundries and other items on the hardware screw packaging machine, clean and disinfect all parts in contact with the product.

2. Check whether the screws are loose during transportation. Rotate the belt one round by hand to check whether the hardware screw packaging machine is stuck or not rotating. Whether there is any reason to find out and eliminate it.

3. Add lubricating oil (select 36# oil) to the moving parts such as the horizontal sealing guide column, cam, and flushing clutch, check whether the reducer is short of oil, if it is lower than the center line of the fuel tank, please add 36# oil.

a) Turn on the power and turn off the leakage switch in the electrical control box.

Set the temperature required for the vertical and horizontal sealing of the mold, so that the temperature on the temperature control table is heated to the temperature required by the coating material.

Start sequence:

1. Put the packaging machine of the furniture accessories automatic packaging machine into trial operation, turn the handle of the blanking clutch to the disconnection mark, and start the empty operation without exception

2. Adjust the stepless speed regulator to the slow position according to the sign.

3. After parking, send the coating material to the longitudinal sealing mold according to the steps of the perforated film diagram along the molding device, click and seal, pull out the drawing paper clutch with the right hand, pull the film into the drawing wheel with the left hand, and close the drawing clutch.

4. Start the packaging mechanism to empty the bag and check its sealing quality.

5. Close the blanking handle and observe whether the blanking time is correct.

6. Pour a small amount of materials into the barrel, start the packaging machine, conduct a packaging test on the finished product, and check whether the packaging weight meets the requirements.

7. After the above preparations are completed, only finished products can be mass-produced.

Shutdown sequence: Disconnect the feed clutch, press the stop button, disconnect the main power switch to make it clean.

Considerations:

1. The operator must be proficient in the above sequence, otherwise it may cause the failure of the automatic packaging machine for furniture accessories.

2. In the working process of the automatic packaging machine for furniture accessories, pay attention to whether the sound of the hardware spiral packaging machine is normal, whether the temperature is normal, whether the packaging film is used up, and whether the material is used up. During the production process, the operator should not leave the packaging machine. If any problems are found, they should stop for inspection in time.

3. When adjusting the organization, it is important to remember the original size and status so that it can return to the original starting point when the adjustment is not ideal.

4. This new machine must run at a slow speed for 100 to 150 hours.

5. Do not put tools and foreign objects on the hardware screw packaging machine, so as not to fall into the mold and damage the mold

6. When hoisting, you must press the button to remove the sealing mold.

7. After working for a long time, a special copper brush should be used to clean the surface of the mold, which is beneficial to the improvement of the sealing quality.

8. In the operation of the automatic packaging machine for furniture accessories, it is strictly forbidden to put your hands or objects near the moving parts.

9. Check whether the fastening parts of the machine are loose and whether they are disconnected regularly.

10. The oil (36#) of the reducer should be changed every 3 months, according to the center line of the oil standard.