The Solution To The Sealing Problem When The Particle Packaging Machine Is In Use

The automatic granule packaging machine, a small machine, can be a complete packaging production line, saving a lot of complicated manpower and material resources. It can be seen that advanced technology, but no matter how advanced the technology, the use of the machine will always fail. We need to understand the cause of the failure to avoid it.

Characteristics of granule packaging machine

Customized vibrating discs for screw test products, parallel line vibration sorting equipment, and high-precision counting and control equipment to ensure the accuracy of each bag. The single-chip microcomputer design automatic control system, common faults self-shutdown, self-alarm, self-diagnosis, application safety.

Ways to solve the sealing problem:

The heat seal leakage seal of the pellet packaging machine is caused by many reasons, so it should be sealed according to the heating, melting and melting position, not sealing.

This is probably due to insufficient heat sealing temperature. The heat-sealing temperature specified at different heat-sealing positions for the same packaged product is different, the heat-sealing temperature specified by different packaging rates is different, and the heat-sealing temperature specified by different packaging working temperatures is also different.

For heat-sealing mechanical equipment, temperature control accuracy is still a problem. At present, the temperature control accuracy of domestic packaging machinery and equipment is weak, and there are usually errors. Problems with machinery, equipment, and operating levels. For example, the heat-sealing mold clamps are dirty, the heat-sealing working pressure is insufficient, and the heat-sealing mold is not parallel.

Many companies use random sampling to inspect the finished products in their seal inspections. I don't think this is a good method. The most reliable method is to sample the lowest temperature point within the temperature change range, and sampling should be continuous so that the sample can fully cover the horizontal and longitudinal positions of the mold.